BioGuard Super Soluble, 5 LB | 21049BIO

Here’s a rewritten version with varied wording while keeping the instructions clear:

Instructions

Make sure all pool equipment is functioning correctly. Backwash the filtration system according to the manufacturer’s guidelines. Adjust the pH level to fall within the range of 7.2-7.6. Add a stabilizer to maintain a minimum level of 30-40 ppm, helping to protect chlorine from being broken down by sunlight. Test for metals in the water. Before applying this product, use a stain and scale inhibitor to prevent metal-induced staining on the pool surface. When using other pool care products as recommended in these instructions, always adhere to the guidelines specified for each product.

With the pump running, evenly distribute 4 oz. of this product per 10,000 gallons of water directly into the deep end of the pool for the initial application. Repeat as needed until a chlorine level of 1-3 ppm is reached, confirmed using a test kit. To avoid surface damage, use a pool brush to spread any granules that settle on the pool floor. Never allow undissolved product to sit in contact with surfaces that may bleach. Frequent water testing is necessary to determine when another dose is required to maintain a 1-3 ppm chlorine residual. On average, a daily dose of 2-3 oz. per 10,000 gallons of water is recommended. After using this product, a weekly preventative algaecide treatment is advised.

Super Chlorination

Distribute 1 lb. of this product per 10,000 gallons of water directly into the deep end of the pool. To prevent damage, use a pool brush to disperse any granules that settle on the bottom. Do not let undissolved granules remain in contact with bleachable surfaces.

If the water temperature is below 70°F or if an alternative application method is preferred, pre-dissolve this product before adding it evenly to the deep end. To do this, dissolve the product outdoors in a clean plastic bucket, stirring with a plastic or wooden utensil. Always add the product to water—never pour water onto the product. Do not dissolve more than 1 lb. of this product in less than 3 gallons of cool water. Avoid mixing with other chemicals when pre-dissolving.